DIELECTRIC HEATING / ELECTRONIC WELDING / RADIO FREQUENCY 
ALL USE THE PRINCIPAL OF MOLECULAR FRICTION

The theory of Dielectric Heating is based on the fact that disturbed water molecules cause friction, and therefore, create HEAT.  The disturbance is caused by very high frequency cycle change (twenty seven million times per second), which moves the water molecules of glue at such a tempo that the friction generates heat, and the glue bond is complete.

The WorkRite Welder will work with any water-based glue on today's market.  Because of the heat generated in the glue line, we recommend pre-catalyzed glue, which achieves faster and stronger results (i.e. Kor Lok, Titebond II, and Wonderbond).  When you see steam in the glue joint or approximately 5 seconds (never more than 10 seconds) has elapsed, move on.  Never overheat your glue; it becomes weak.

The WorkRite Welder has been certified to pass all occupational and controlled exposure standards set fourth by the code of Federal Regulations No.  WRK-001A.  It is registered and fully described in a report filed with the FCC.

WorkRite Inc.
1315 South Flower St.
Burbank, CA 91502
Phone (818) 241-3682
Fax (818) 559-5457